ASSEMBLY
1. Unpack the air compressor and inspect the unit for
damage and parts. If the unit has been damaged or
some parts are missing, contact the Service Center
immediately.
2. Check the serial tag label to ensure that it has the
required pressure rating for its intended use.
3. Take out one(1) pad(A), one(1) bolt(B), one (1)
washer(C), one(1) nut(D) from the bag and install
them on the front stand of the tank. (See Figure 2)
4. Take out two(2) wheels(A), two(2) bolts(B), four(4)
washers(C), two(2) nuts(D) from the bag and install
them on the foot section of the tank. (See Figure 3)
5. Unpack the smaller plastic bag with the air filter
included and have the air filter (A) assembled on
the pump. (See Figure 4)
6. Install the handle(A) by inserting the both ends into
the base and secure with four(4) bolts(B) provided.
(See Figure 5)
7. Locate the compressor according to the following
guidelines:
a. Set the compressor in a position near a
grounded electrical outlet.
b. The compressor must be at least 12 inches
away from any wall or obstruction and in a
clean, well-ventilated area, to ensure sufficient
air flow and cooling.
c. The compressor must be level to ensure
proper drainage of the moisture in the tank.
d. In cold weather, store the compressor in a
heated building when not in use. This will
reduce problems with the motor starting and
freezing from water condensation.
8. Connect an air hose with a 1/4” NPT fitting kit to the
compressor air line outlet.
(One 25’ recoil air hose included in the pneumatic
accessory kit. You can get a longer air hose upon
your intended use)
Figure 2
Figure 3
Figure 4
Figure 5
B
A
C
D
D
C
A
B
A
B
A
- 6-