COLEMAN
®
TENT LIGHTING SYSTEM / ÉCLAIRAGE DE TENTE COLEMAN
®
TENT LIGHTING
SYSTEM
How to Use and Enjoy Your Coleman
®
SYSTÈME D’ÉCLAIRAGE
DE TENTE
Profitez au maximum de ce système Coleman
®
Carefully read all instructions before use and save for future reference.
TO INSTALL OR REPLACE POWER P
ACK BATTERIES
Your new Coleman
®
Tent Lighting System operates on 8 “D” cell batteries. For longest life
use alkaline batteries.
1.
If Red Button on front of batter
y pack is glowing, push button to turn power “OFF”. (Fig. 1)
2.
Turn batter
y pack over and place coin into slot and rotate to unlock. (Fig. 2)
3. Lift up lid and install 8 batteries in the correct orientation as shown on the battery
compartment. Always be careful that batteries are installed correctly. (Fig. 3)
4. Close lid, insert coin into slot and rotate to locked position.
5. Place battery pack in pocket sewn into side of tent. (Fig. 4)
NOTE:
Never operate tent light if battery pack is not stored in upright position, with
red button facing outward, in pocket.
TO REPLACE REMOTE CONTROL BATTER
Y
NOTE:Remote control feature is not available on all versions
of this Coleman
®
Tent Lighting System.
1. Remove 4 screws from back of transmitter and install one
12v, 23AE alkaline batter
y. (Fig. 7)
2.
Reassemble transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including inter
ference that may cause undesired operation.
Warning
: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This device complies with Part 18 of the FCCRules.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that inter
ference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the inter
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that which the receiver is needed.
• Consult the dealer or an experienced radio/TV technician for help.
Note:
This product may cause interference to radio equipment and should not be installed near maritime safety
communications equipment or other critical navigation or communication equipment operating between 0.45-30 MHz.
The Responsible Party information as below:
• Applicant name in full: The Coleman Company, Inc.
• Phone: (316) 832-3056
• Address: 3600 N. Hydraulic, Wichita, KS 67219
• Fax: (316) 832-6193
• Contact in USA: Randy Hoover / Director of Product Safety Compliance
• Email address: [email protected]
Fig. 4
Fig. 2
Fig. 1
Fig. 3
TO CHANGE FLUORESCENT TUBE
NOTE:
This tent light uses one 15-watt fluorescent spiral
tube (See Parts List for replacement part #). Fluorescent
spiral tubes are very fragile. Handle with care.
1.
Make sure power pack light is turned “OFF” and
red button is not glowing.
2.
Grasp globe on tent light and turn clockwise to
remove. (Fig. 5)
3.
Gently press down on fluorescent spiral tube and
turn counterclockwise until both alignment tabs
are visible in locating slots of housings. Remove
tube. (Fig. 6)
4.
Install new fluorescent spiral tube by placing alignment tabs in locating slots of
reflector. Gently push down and rotate clockwise until secure.
5.
Reattach globe to light housing by turning counterclockwise until tightened.
Do not overtighten.
TENT FLOOR
SIDE OF TENT
Fig. 6
Fig. 5
Fig. 7
TO OPERATE TENT LIGHT
1.
Screw tent light into socket at top of tent
by turning clockwise. (Fig. 8)
2. Unsnap rubber plug from side of power pack
and plug the power cord that was installed
in your tent into the power pack. (Fig. 9)
3. Push the red button on the power pack to
turn on main power. The button on the
power pack and the tent light will glow when
main power is “ON”. (Fig. 9)
4. Push red button on tent light: a) once for
“HIGH” light setting, twice for “LOW” light
setting, a third time will turn light “OFF”.
(Fig. 10)
TO OPERATE TENT LIGHT WITH REMOTE CONTROL
1. Push the red button on the power pack to turn on main power. The
button on the power pack and the tent light will glow when main
power is “ON”.
(Fig. 10)
2. Push the button on the remote control transmitter: a) once for
“HIGH” light setting, twice for “LOW” light setting, a third time will
turn light “OFF”. (Fig. 11)
Fig. 9
Fig. 11
Fig. 10
LIGHT
RED BUTTON
RED BUTTON
TRANSMITTER
BUTTON
ALIGNMENT
TABS
CLOSE OPEN
Fig. 8
Fluorescent tube(s) contains mercur
y (Hg) and must be
recycled or disposed of according to local, state or federal
laws. Call (800) 835-3278 or visit
www.coleman.com/recycle
for recycling instructions or safe disposal locations
.
COLEMAN
®
TENT LIGHTING SYSTEM / ÉCLAIRAGE DE TENTE COLEMAN
®
Rev 08/2007
5-Year Limited Warranty
The Coleman Company, Inc. (“Coleman”) warrants that for a period of five years from the date of original retail purchase,
this product will be free from defects in material and workmanship. Coleman, at its option, will repair or replace this
product or any component of the product found to be defective during the warranty period. Replacement will be made with
a new or remanufactured product or component. If the product is no longer available, replacement may be made with a
similar product of equal or greater value. No warranty is provided for batteries and lightbulbs.
This is your exclusive warranty.
This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep
the original sales receipt. Proof of purchase is required to obtain warranty performance. Coleman dealers, service centers,
or retail stores selling Coleman® products do not have the right to alter, modify or in any way change the terms and
conditions of this warranty.
What This Warranty Does Not Cover
This warranty does not cover normal wear of parts, parts that are not genuine Coleman® parts, or damage resulting
from any of the following: negligent use or misuse of the product; use on improper voltage or current; commercial use of
the product; use contrary to the operating instructions; disassembly, repair or alteration by anyone other than Coleman or
an authorized service center. Further, the warranty does not cover Acts of God, such as fire, flood, hurricanes and
tornadoes. Warranty void if damage to product results from the use of a part other than a genuine Coleman® part.
COLEMAN SHALL NOT BE LIABLE FOR DEFECTS THAT ARE CAUSED BY THE USE OF UNAUTHORIZED PARTS OR
SERVICE. COLEMAN SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES CAUSED BY THE
BREACH OF ANY EXPRESS OR IMPLIED WARRANTY OR CONDITIONS. EXCEPT TO THE EXTENT PROHIBITED BY
APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE IS
LIMITED IN DURATION TO THE DURATION OF THE ABOVE WARRANTY OR CONDITIONS. SOME STATES, PROVINCES,
OR JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES
OR LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSION MAY
NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER
RIGHTS THAT VARY FROM STATE TO STATE OR PROVINCE TO PROVINCE.
How to Obtain Warranty Service
Take the product to an authorized Coleman service center. You can find the nearest authorized Coleman service center by
visiting
www.coleman.com
or calling 1-800-835-3278 or TDD 316-832-8707 in the United States or 1 800 387-6161 in
Canada. If a service center is not conveniently located, attach to the product a tag that includes your name, address,
daytime telephone number and description of the problem. Include a copy of the original sales receipt. Carefully package
the product and send either by
courier
or
insured mail
with shipping and insurance prepaid to:
For products purchased in the United States:
The Coleman Company, Inc.
3600 North Hydraulic
Wichita, KS 67219
The costs of transporting the product to Coleman or an authorized service center for
warranty service is the responsibility of the purchaser.
DO NOT RETURN THIS PRODUCT TO THE PLACE OF PURCHASE.
DO NOT SHIP WITH THE BATTERIES INSTALLED.
If you have any questions regarding this warranty please call
1-800-835-3278 or TDD 316-832-8707.
©2007 The Coleman Company, Inc. All rights reserved.
Coleman®, , and are registered trademarks
of The Coleman Company, Inc.
For products purchased in Canada:
Sunbeam Corporation (Canada) Limited
DBA Jarden Consumer Solutions
20B Hereford Street
Brampton (Ontario) L6Y 0M1
