IDLE SPEED
ADJUSTMENT
The idle speed should be set at
1700 +- 100 RPMs
To adjust the idle speed:
1. Locate the idle adjustment
screw (1) located on the carbure-
tor.
2. Allow the engine to warm up
approximately 10 minutes
3. With the engine running, turn
the idle adjustment screw in or out
at small increments until the
correct idle is achieved.
Note: A service center can perform
this adjustment . A diagnostic
tachometer is required for this
adjustment.
1
MAINTENANCE
2
SHOCK ABSORBER
ADJUSTMENT
The front and rear shocks each have
an adjustable ring. The default
position has been set by the
manufacture. The tension of the
shock will change depending on the
position of the adjustment ring (2).
To increase to a stiffer
suspension, rotate the adjustment
ring clockwise. To decrease to a
lighter suspension, turn adjustment
ring counterclockwise. Generally
heavier riders will want suspension
adjusted to a stiffer position so the
shocks will not bottom out while
going over bumps.
Do NOT attempt to operate this kart
if the shocks in the front are not
adjusted to the same settings.
Do NOT attempt to operate this kart
if the shocks in the rear are not
adjusted to the same settings.
27
