HEAT OPERATION
(cooling only models without)
Press the "MODE" button until the
"HEAT" indicator light comes on.
Press the ADJUST buttons "+" or "
- " to select your desired room
temperature. The temperature can be
set within a range of 62 -88 17 -30 .
Press the "FAN SPEED" button to
choose the fan speed. For some
models, the fan speed can not be
adjusted under HEAT mode.
Press the "MODE" button until the
"DRY" indicator light comes on.
Under this mode, you cannot select a
fan speed or adjust the temperature.
The fan motor operates at LOW speed.
Keep windows and doors closed
for the best dehumidifying effect.
Do not put the duct to window.
AUTO OPERATION
When you set the air conditioner in
AUTO mode, it will automatically
select cooling, heating(cooling only
models without), or fan only
operation depending on what
temperature you have selected.
and the room temperature.
The air conditioner will control room
temperature automatically round the
temperature point set by you.
Under AUTO mode, you can not
select the fan speed
TIMER OPERATION
When the unit is on, press the
Timer button will initiate the Auto-
off stop program, the TIMER OFF
indicator light illuminates. Press
the UP or down button to select the
desired time. Press the TIMER
button again within 5 seconds, the
Auto-on start program is initiated.
And the TIMER ON indicator light
illuminates. Press the up or down
button to select the desired Auto-on
start time.
When the unit is off, press the
Timer button to initiate the Auto-
on start program, press it again
within five seconds will initiate
the Auto-off stop program.
Press or hold the UP or DOWN
button to change the Auto time by
0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24
hours. The control will count down
the time remaining until start.
The system will automatically
revert back to display the previous
temper-ature setting if there is no
operation in a five seconds period.
Turning the unit ON or OFF at
any time or adjusting the timer
setting to 0.0 will cancel the
Auto Start/ Stop timer program.
When the malfunction (E1,E2,E3
or E4) occurs, the Auto Start/Stop
timed program will also be cancelled.
