4 .11 About Connecting via Telnet to the XT-100
You can access the XT-100 via an Ethernet Socket connection using the Telnet (or equivalent) utility. The default port # is 5025. A telnet
session can be opened with using the hostname or the IP address of the XT-100.
After a connection is established, enter SCPI commands to communicate to the XT-100. See Chapter 6 Application Programming
Interfaces and Commands.
4 .12 Setting the delay over RS-232 Serial Port and PC
The RS-232 Serial Port is located on the back panel of the XT-100 System Unit and is used to connect to either the MT-100A Microterminal
(with the supplied DB-9 male to female cable) or to a PC (with a null model DB-9 female-to-male cable). Port speed is 9600 baud, 8 data
bits, and 2 stop bits.
The XT-100 system unit can operate (send command prompts and receive command data) in either Terminal Mode or in MT-100A
Mode. You must specify the correct mode prior to attaching either the MT-100A Microterminal or the PC else command prompts will be
displayed incorrectly. Default is MT-100A Mode with the Microterminal attached when the XT-100 is first powered-on.
10
COLBY INSTRUMENTS XT-100 VERSION 1.0 OPERATING AND PROGRAMMING MANUAL
