Coitech 18-3235, Original Instructions Manual

Page: 8 / 32

8
EN
G
LI
S
H
3
9
10 8
1
11 12
1
6 4
Operation
Setting the speed
1. Set the speed using the buttons [+] and [–]
(6). The display shows 1/1000 of the actual
number of revolutions. The machine in
the figure is set on 8000 rpm.
2. Start the machine using the on/off switch.
The speed can be adjusted when
the machine is running.
3. Switch the machine off using
the on/off switch (4).
Attaching accessories
1. Press in the spindle lock button (3)
and undo the collet chuck (1).
2. Insert an accessory into the chuck and then
tighten the chuck. The collet (9) might need
to be changed depending on the shank
diameter of the accessory. Two collets are
supplied: 2.4 mm and 3.2 mm.
Attaching flexible drive shaft
1. Unscrew the nose collar (2).
2. Pull the drive wire (10) a short way out of
the flexible drive shaft (8) and grip the end of
it in the collet chuck (1) (3.2 mm).
3. Screw the flexible shaft to
the thread on the machine where
the nose collar was.
4. Lock the flexible drive shaft by inserting
the spindle lock pin (11) into the hole at
the nose.
5. Undo the collet chuck (12) and attach
the desired accessory before tightening it again.