10
6X-1105D
Figure 2. Interconnection Diagram. Camera Positioner System
Network
Switch
Power
Router/Switch
CAT5e
Cable
Router/Switch
WAN
LAN
System Cable
Be sure to mount the camera system
before the power is applied.
Do not apply power before
installation is complete.
Earth
Ground
Cable Shield(s)
Default IP Address
192.168.2.150
2.1 System Cable Requirements
To build a camera system cable, CohuHD recommends:
• For Ethernet: CAT5e or better cable. For distances up to 100 meters (328 feet), use CAT5e cable
with four pairs of copper wire, 24 AWG.
NOTE:
The maximum recommended cable length for Ethernet is 100 m (328’). However, other
factors may reduce the distance Ethernet can be successfully used, such as EMI from other
sources.
• When wiring to the Ethernet pins, consider if they are to be wired for the NIC (Network Interface
Card) in a PC or for system connections to a hub, switch, router, or similar device. See Tables 1
and 2.
Table 1. Ethernet Cable Wiring to a Hub, Switch, or Router (Straight Wiring)
Ethernet
Function
Camera Connector
Ethernet Pins
Camera Positioner
Ethernet Pins
Corresponding
RJ-45 Ethernet Pins
Tx+
A
4
1
Tx-
B
5
2
Rx+
C
22
3
Rx-
D
23
6
This Ethernet wiring is intended to connect directly to a hub, switch, or router. For connection
directly to a PC it will be necessary to use either a crossover cable or a crossover adapter.
See Table 2. Note: For clarity, only signal lines are shown.
