CognitiveTPG A776 ColorPOS, Programming Manual

Page: 23 / 180

Chapter 3: Migrating to a new printer
A776-PG00001 D 07/13 A776 (B780) Programming Guide
11
Set Page Mode Margin Mechanical Adjustment
Code (Hexadecimal)
1F 03 25 16 n
· This command applies to both the A776 and the B780, although it is primarily implemented for B780 printers
replacing existing A721 printers to match cashier check printing.
· Default is 0.
· Value is printed on the second diagnostic page.
· Ranges for margin configurations:
Margin Setting Maximum mechanical adjustment
.5
”
30 half dots
.3
” 56 half dots
.1
”
84 half dots
· Mechanical adjustment does not apply when page size is defined to be greater than the default of 200 full
dots wide.
Select A776 Slip Eject Option
Code (Hexadecimal)
1F 03 25 17 n
n Slip Eject
00 disabled
01 enabled (default)
. When enabled, the A776 will eject slip and validation transactions out the top of the printer, like the B780. The
slip LED will blink to remove the form, also like the B780.
· Option can be disabled for applications that rely on the A760 slip eject out the bottom front position.
Select 45/60 Column Slip Option
Code (Hexadecimal)
1F 03 25 18 n
n 45/60 Column Slip Option
00 disabled (default)
01 enabled
Set Page Mode Option to Trim Full Dots
Code (Hexadecimal)
1F 03 2F n
n < 128
# of full dots trimmed from right side
n = 255
compress to fit in 3.024
”
. This command applies to both the A776 and the B780, although it is primarily implemented for applications
specifying a page size greater than 242 full dots wide.
· Default is no trim.
· Maximum width that can be compressed to fit in 3.024” is 270 full dots.
· Value is printed on second diagnostic page.