Cognex ISC-7000 Series, Manual

Page: 10 / 104

3. Place the adapter on the faceplate of the camera. Insert the four adapter
screws and tighten; the maximum torque is 0.90 Nm (8 in-lb).
4. Thread the lens into the camera.
5. Attach the cover to the camera. Rotate the cover clockwise approximately
seven degrees to lock it.
Install the Mounting Bracket (ISB-7000-7K)
Complete the following steps to attach the accessory mounting bracket (ISB-7000-
7K) to the camera.
CAUTION :
l
The camera should be grounded, either by mounting the camera to a
fixture that is electrically grounded or by attaching a wire from the
camera’s mounting fixture to frame ground or Earth ground. If a
ground wire is used, it should be attached to one of the four mounting
points on the back plate of the camera; not to the mounting points on
the front of the camera.
l
When mounting the camera to the mounting bracket, use the M3
screws supplied with the mounting kit. If using the 1/4 - 20 or M6
screw holes on the mounting bracket to secure the camera to a
mounting surface, the insertion depth of the screw should not exceed
7mm. Allowing the mounting screws to bottom in the mounting hole
can damage the camera.
1. Align the mounting bracket with the mounting holes on the camera.
2. Insert the M3 screws into the mounting holes and tighten using a 2.5mm hex
wrench; the maximum torque is 0.90 Nm (8 in-lb).
9