Cognex In-Sight 5000 Series, Installation Manual

Page: 23 / 48

5400CS, 5403S and 5400S Vision System Specifications
Table 3-2: 5400CS, 5403S, 5400S Vision System Specifications
Specification 5400CS 5403S 5400S/5410S
Minimum
Firmware
Requirement In-Sight version 4.4.3
Job/Program
Memory 128MB non-volatile flash memory; unlimited storage via remote network device.
Image
Processing
Memory 256MB SDRAM
Sensor Type 1/3-inch CCD 1/1.8-inch CCD 1/3-inch CCD
Sensor
Properties 5.92mm diagonal,
7.4 x 7.4µm sq. pixels 8.80mm diagonal,
4.4 x 4.4µm sq. pixels 5.92mm diagonal,
7.4 x 7.4µm sq. pixels
Resolution
(pixels) 640 x 480 1600 x 1200 640 x 480
Electronic
Shutter Speed 16µs to 1000ms 27µs to 1000ms 16µs to 1000ms
Acquisition Rapid reset, progressive scan, full-frame integration.
Bit Depth 24-bit color. 256 grey levels (8 bits/pixel).
Frames Per
Second
1
60 full frames per second. 14 full frames per second. 60 full frames per second.
Lens Type C-mount
Lens Cover
View Port
Material Clear plastic with an abrasion-resistant coating on the exterior side.
Trigger 1 opto-isolated, acquisition trigger input. Remote software commands via Ethernet and RS-232C.
Discrete Inputs None built-in. Additional inputs available using a compatible I/O module (For more information, refer
to
I/O Modules on page 4
.). Unlimited inputs when using an Ethernet I/O system.
Discrete
Outputs 2 built-in, high-speed outputs. Additional outputs available using a compatible I/O module (For more
information, refer to
I/O Modules on page 4
.). Unlimited outputs when using an Ethernet I/O system.
Status LEDs Power, Network Status, Network Traffic, 2 user configurable.
Network
Communication 1 Ethernet port, 10/100 BaseT, TCP/IP protocol. Supports DHCP (factory default), static and link-local
IP address configuration.
1588 Support
Timestamp Resolution: 8ns
Synchronization Accuracy Through Transparent Clock: 5µs
Serial
Communication RS-232C when connected to the Breakout Cable or a compatible I/O module. (For more information,
refer to
I/O Modules on page 4 .).
Power
Consumption 24VDC ±10%, 500mA maximum.
Material ASTM 316L Stainless Steel.
Finish Electropolish Passivated.
Mounting Four M4 threaded mounting holes on back of vision system.
Dimensions
90.6mm (3.57in) x 124.0mm (4.88in) x 61.4mm (2.42in) with lens cover installed.
43.5mm (1.71in) x 124.0mm (4.88in) x 61.4mm (2.42in) without lens cover installed.
Weight 907 g (32.0 oz.) Lens cover installed, without lens.
1
Maximum frames per second is job-dependent, based on the minimum exposure for a full image frame capture using the dedicated acquisition
trigger, and assumes there is no user interface connection to the vision system.
Specifications
11