Cognex In-Sight 5000 Series, Installation Manual

Page: 16 / 48

I/O Module Cable
The I/O Module cable connects the vision system directly to a compatible In-Sight I/O module via the DB15 connector.
The pin-outs for the cable are listed in the I/O Module Cable Specifications on page 23 . This cable is available in the
lengths listed below.
Figure 1-3: I/O Module Cable
Table 1-5: I/O Module Cable Lengths and Styles
Length Standard Part # 45-Degree Key Right-Angle Part # 35-Degree Key Right-Angle Part #
2 m CCB-84901-0901-02 CCB-84901-4001-02 CCB-84901-5001-02
5 m CCB-84901-0902-05 CCB-84901-4002-05 CCB-84901-5002-05
10 m CCB-84901-0903-10 CCB-84901-4003-10 CCB-84901-5003-10
15 m CCB-84901-0904-15 CCB-84901-4004-15 CCB-84901-5004-15
I/O Modules
The following I/O modules are compatible with your vision system, and provide access to additional discrete inputs and
outputs.
Table 1-6: I/O Module Compatibility
I/O Module Vision System Discrete Inputs Discrete Outputs
CIO-1400
All In-Sight 5000 series vision systems
(except In-Sight 5604)
7 general
2 high-speed,
6 general
CIO-MICRO and CIO-MICRO-
CC
12
All In-Sight 5000 series vision systems
3
8 general
2 high-speed,
8 general
1
The CIO-MICRO and CIO-MICRO-CC I/O modules do not support 1000 BaseT pass-through operation. If 1000 BaseT operation is required
when using the In-Sight 5600 series vision system, you must connect a LAN cable from a Gigabit Ethernet switch to the I/O module’s LAN port
and connect the vision system’s Ethernet cable to the Gigabit Ethernet switch.
2
The CIO-MICRO-CC I/O module also adds CC-link networking capability. Refer to the In-Sight
®
CIO-MICRO and CIO-MICRO-CC I/O
Module Installation Manual for detailed connection information.
3
The CIO-MICRO & CIO-MICRO-CC I/O modules support In-Sight 5100 series and 5400 series vision systems with 128MB non-volatile flash
memory or higher and support all In-Sight 5600 series vision systems.
4