Cognex In-Sight 2000 Series, Manual

Page: 6 / 84

Precautions
Observe these precautions when installing the Cognex product, to reduce the risk of
injury or equipment damage:
l
This device requires the use of an LPS or NEC class 2 power supply. Any
other voltage creates a risk of fire or shock and can damage the
components. Applicable national and local wiring standards and rules must
be followed.
l
To reduce the risk of damage or malfunction due to over-voltage, line noise,
electrostatic discharge (ESD), power surges, or other irregularities in the
power supply, route all cables and wires away from high current wiring or
high-voltage power sources.
l
Do not install Cognex products where they are directly exposed to
environmental hazards such as excessive heat, dust, moisture, humidity,
impact, vibration, corrosive substances, flammable substances, or static
electricity.
l
Do not expose the image sensor to laser light; image sensors can be
damaged by direct, or reflected, laser light. If your application requires the
use of laser light that may strike the image sensor, a lens filter at the
corresponding laser's wavelength is recommended. Contact your local
integrator or application engineer for suggestions.
l
Changes or modifications not expressly approved by the party responsible
for regulatory compliance could void the user’s authority to operate the
equipment.
l
Service loops should be included with all cable connections.
5