Preface
This document describes the Cognex CFG-8724 frame grabber.
Precautions
To reduce the risk of injury or equipment damage, observe the following precautions when you install the Cognex
product:
l
Route cables and wires away from high-current wiring or high-voltage power sources to reduce the risk of
damage or malfunction from the following causes: over-voltage, line noise, electrostatic discharge (ESD), power
surges, or other irregularities in the power supply.
l
Do not install Cognex products where they are exposed to environmental hazards such as excessive heat, dust,
moisture, humidity, impact, vibration, corrosive substances, flammable substances, or static electricity.
l
Changes or modifications not expressly approved by the party responsible for regulatory compliance could void
the user’s authority to operate the equipment.
l
Include service loops with cable connections.
l
Ensure that the cable bend radius begins at least six inches from the connector. Cable shielding can be
degraded or cables can be damaged or wear out faster if a service loop or bend radius is tighter than 10X the
cable diameter.
l
This device should be used in accordance with the instructions in this manual.
l
All specifications are for reference purposes only and can change without notice.
Symbols
The following symbols indicate safety precautions and supplemental information:
WARNING
:
This symbol indicates a hazard that could cause death, serious personal injury or electrical shock.
CAUTION
:
This symbol indicates a hazard that could result in property damage.
Note
: This symbol indicates additional information about a subject.
Tip
: This symbol indicates suggestions and shortcuts that might not otherwise be apparent.
4
Preface
