30
CHAPTER 3
®
3.1.2. Access to programming
By pressing the
F
key of the programming keypad, the
programming menu is directly accessed. In case a programming
access code was set, after pressing the
F
key it will be necessary
to enter the corresponding PIN code.
The Aeterna Coin Mechanism foresees
3 user profiles
identified on the display by a corresponding
symbol:
operator
(
),
technician
(
) and
user
(
) (see para. “4 Security”).
After entering the possible access password on the display is
shown the current
menu item,
the
number
of the programming
menu and on the left of the display the
symbol of the profile
enabled
at that moment (ex. Operator profile=
).
If the PIN is not set, there is no restriction to access the Coin Mechanism menus. In this case
everybody who enters the programming mode can access all programming and control functions of
the Aeterna Coin Mechanism.
The Aeterna Coin Mechanism is configured so that after 90 seconds of idleness inside the
programming menu, it automatically quits the menu and the Coin Mechanism starts
again.
3.2. Programming by means of keypad
3.2.1. Programming Menu
The menu reported in these pages is the complete version, which refers to all the items form-
ing the Aeterna Change Giver Coin Mechanism programming. To get the menus divided ac-
cording to the protocol, it is necessary to refer to the legend reported here below or to the
enclosures of this manual. In order to change the operation mode of the Coin Mechanism re-
fer to the note indicated at the “6.1 Protocol” menu item.
Legend of symbols displayed
(
) Operator
(
) Technician
(
) User
X = Level 1 menu
X.X = Level 2 menu
X.X.X = Level 3 menu
X.X.X.X = Level 4 menu
X.X.X.X.X = Level 5 menu
= Predefined menu option
-
= display flashes
= Open lock
= Closed lock
= Password entering
PIN
[0***]
Tube Counters
[ 1]
