Loading your NanoMute settings:
Settings previously saved to your Windows PC can be easily uploaded to your NanoMute via USB. Again, the process is
similar to loading the firmware and the steps are as follows:
1) Connect the NanoMute to your PC
’s USB port.
2) Double-click on the
“- Load Settings.bat” file (previously unzipped from “NanoMute.zip”).
3) Enter the COM port number (digits only, then press
‘enter’).
4) Enter the name of the settings file to load (in quotes) and press enter.
Your settings file must be located in the same folder as your Load Settings.bat file
Note:
Some versions of the Nano bootloader do not support this option.
(Optiboot 8 with Bigboot and Eeprom support is recommended)
Power considerations:
You can easily find cell phone Li-ion battery packs at your local dollar store that are perfect for powering your NanoMute.
These inexpensive units provide enough power to run the NanoMute for days between charges.
Other considerations:
Like any single cable midi controller, the NanoMute only sends midi commands to the XR18, so you should
“sync” the
status of any switches programmed as
“Mute” by pressing them twice after connecting to the XR18. Any changes made to
the XR18 by other devices (PC, tablet, or phone) will not be received by the NanoMute, so any
“Mute” switches affected
by these may require a re-sync.
Feel free to contact me with any questions or commen
ts…
Enjoy!
