COFFEtek GENEVA, Operator'S Manual

Page: 16 / 19

COFFEtek LTD
16 OPERATOR MANUAL GENEVA
A
FILTER BELT REMOVAL AND REPLACEMENT
(1) Using fore finger and thumb compress the tensioning rollers as shown in
A.
(2) With the rollers compressed push and turn the red lever n to the locked
position as shown in B .
(3) With the rollers locked in the compressed position the belt can now be
removed.
(4) The belt may be cleaned using de-staining solution but will progressively
become blocked with scale and therefore require more frequent cleaning.
A new belt will perform approximately 2000 vends before cleaning is
required. It is recommended that a belt is replaced in any case after
approximately 4000 vends.
(5) Replace the filter belt making sure to thread the bottom edge beneath
the scraper plate. Once the belt has been threaded over all three rollers
it can be eased into place by sliding it sideways whilst turning the drive
shaft.
(6) Once the belt is in place press the red lever to release the tensioning
roller and tighten the belt.
B
1