12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901
4. Service.
Installation and start
Prince
1.
Place the brewer on a flat
level and waterproof surface.
Connect the electrical plug to a separate
grounded wall socket
Grounded wall socket
230V 10A
OBSERVE!
Make sure there is a space behind the machine
for free flow of air.
( minimum 10cm ).
2.
Connect attached water tube to cold water with an R 1/2”.
Make sure that the water hose not are kinked anywhere when machine is
pushed into place.
Please flush the water tube before connecting to machine, this to avoid any
particles to damage the inlet valve.
3.
Open the water inlet.
4.
Turn on the ON-OFF switch inside the door.
Water is been filled into the tank automatically with
6,0 litres of water. The heating will not start before
the water level reaches the level sensor.
Set temperature is approx. 85ºC.
5.
Close door.
6
.
ON / OFF
Switch
