4. Service. Installation and start-up
Fast Mash New
1.
Place the machine on a fl at
Connect the plug to an
waterproof surface.
earthed
230V
10A
wall
outlet.
Note: Make sure air is able to circulate freely
behind
the
machine.
2.
Connect the factory-supplied tube to the
cold water feed
using a ½” R- connection
piece. Make sure no folding or sharp bending occurs when you push the machine
back
in
place.
If the water pipeline is new, fl ush the system with water fi rst to remove
copper shavings. These can damage the inlet valve.
3.
Open the water tap.
4.
Hit the ON/OFF switch inside the panel.
The water tank will fi ll automatically with
1.8 litres of water.
The element will not be powered until the water
reaches the level indicator.
the temperature is set to 85º Celsius.
5.
Shut the panel door. The mash machine is ready
to be used within approx. 10 minutes.
8
.
ON/OFF
switch
