6
English
2.3. Certification
2.2. Warranty conditions
1.
The fixture is guaranteed for a period of 12 months against manufacturing faults and faulty materials.
2.
Faults due to incorrect operation or operation in an inappropriate manner are not covered by the warranty.
3.
The warranty is immediately void if the fixture has been operated or serviced by unqualified or unauthorised personnel.
4.
The warranty does not include fixture replacement.
5.
The model and serial numbers must be supplied for any warranty claims or advice from our authorised service personnel.
2.1. Important safety information
Fire prevention:
1.
Never locate the fixture on any flammable surface.
2.
Minimum distance from flammable materials: 0,5 m.
3.
Minimum distance from the closest illuminable surface: 0,5 m.
4.
Replace any blown or damaged fuses only with those of identical values. Refer to the schematic diagram if there is any doubt.
Preventing electric shock:
1.
High voltage is present in the internals of the unit. Isolate the projector from mains supply prior to performing any function which
involves touching the internals of the unit, including lamp replacement.
2.
For mains connection, adhere strictly to the guidelines outlined in this manual.
3.
The level of technology inherent in the
Stage Lite Led
requires the use of specialised personnel for all service applications; refer all
work to your authorised
Coemar
service centre.
4.
A good earth connection is essential for proper functioning of the projector.
5.
Mains cables should not come into contact with other cables. Never operate the unit without proper earth connection.
6.
Do not operate the projector with wet hands or in an area where water present.
Safety:
1.
The projector should always be installed with bolts, clamps, and other fixings which are suitably rated to support the weight of the unit.
2.
Always use a secondary safety chain of a suitable rating to sustain the weight of the unit in case of the failure of the primary fixing point.
3.
Never install the fixture in an enclosed area lacking sufficient air flow; the ambient temperature should not exceed 35°C.
4.
The external surface of the unit, at various points, may exceed 80°C. Never handle the unit until at least 10 minutes have elapsed
since the lamp was turned off.
Protection rating of the body against liquids and solids (IP 65 version):
1.
The fixture has an IP65 protection rating; this indicates that it is protected against dust and significant showers of water. This protection
rating allows the fixture to be installed in an exposed location in inclement weathe conditions.
2. General information
1.1. Packaging
Open the packaging and ensure that no part of the equipment has suffered damage in transit. In case of damage to the equipment,
contact your carrier immediately by telephone or fax, following this with formal notification in writing.
Packing list
Ensure the packaging contains:
1 Stage Lite Led
1 instruction manual
2 cam-lock support brackets for suspended installation
2 cam-lock support brackets for floor installation
1.2. Transportation
The
Cyc Lite Led
should be transported in its original packaging or in an appropriate flight case.
1. Packaging and transportation
Congratulations on having purchased a
Coemar
, you have assured yourself a fixture of the highest quality, both in componentry and
in the technology used. We renew our invitation to you to complete the service information on the previous page, to expedite anty
request for service information or spares (in case of problems encountered either during, or subsequent to, insallation). This information
will assist in providing prompt and accurate advice from your
Coemar
service center.
Following the instructions and procedures outlined in this manual will ensure the maximum efficiency of this product for years to come..
According to article 13 of D.L. July 25th 2005, n° 151 “Implementing directives 2002/95/CE and 2003/108/CE, regar-
ding the reduction of the dangerous substances usage in the electric and electronic devices, and the disposal of waste
materials.
1.
The fixture meets the essential requirements of the directive EMC 89/336/EEC, 93/68/EEC, BT73/23/EEC.
2.
The fixture is in accordance with the standard EN 50419 (RoHS) and satisfies the requirements of the directive
2002/96/EC (WEEE).