5.1. Operating voltage and frequency
The projector may operate at voltages of
208V
,
230V
or
240V AC
at a frequency of 50 or 60Hz.
Coemar
presets (barring specific
requests) a voltage of 230V at a frequency of 50Hz. The preset voltage and frequency is indicated on the base of the projector.
5.2. Altering the operating voltage and frequency
(Reserved for technical personnel only)
If the factory preset operating voltage and frequency do not correspond to those in use in your country of operation, you may alter the
settings as described in the following paragraphs.
Loosen the screws
“A”
on the cover of the base of the unit, as shown in the diagram below, using an appropriate screwdriver, thereby
removing the two covers completely and allowing access to the internal components of the base of the
miniCYC MB
.
Locate the transformer in the base of the unit.
Select a voltage from amongst 208V, 230V or 240V by disconnecting cable n° 5 and moving it to the correct voltage. Refer to the stic-
ker located on the transformer to ensure the proper terminal is selected for your requriements.
Cable number 8 must not have its position altered under any circumstances
!
A
ATTENTION!!
Incorrect selection of operating voltage and frequency will seriously compromise the
functioning of the projector and will immediately void the warranty.
5. Powering up
10
English