6. Powering up
manual system 6
requires a + 20V DC supply; it is electronically set to recieve this from appropriate
coemar
products or via
an appropriate external power supplyl.
6.1. ex20V DC power supply
The +20V DC 200 mA. power supply should be connected to the socket at the rear of the controller.with an appropriate plug
to suit the
manual system 6
:
Two core, Ø internal 2,1mm, Ø external 5,5mm.
For 230V 50/60 Hz mains supplies, we recommend the use of a
coemar
power supply which is available from distributors
with stock code:
FO644/2
(power supply 230V 50/60Hz)
Power reception is indicated by the switching on of the dmx out led which will remain static on for 5 seconds and will then
flash whilst it monitors outgoing dmx 512 signal.
6.2. power supply from the dimmer
Most
coemar
dimmers manufactured since 1982 will automatically power up the
manual system 6
via their analogue con-
nections
Check that your fixture is supplying
+20V DC via pin number 7
of the locking-din and that
0V is via pin number 8
.
To power up the
manual system 6
connect it as described in section 3 regarding 0/+10V Dc connection, and as in the dia-
gramme..
8 pin locking DIN/M
8 pin locking DIN/M
in
2
3
4
5
6
7
1
8
control output:
0/+10v
segnale di uscita:
Power supply requirements:
Tensione di alimentazione:
+20v DC only 200 mA max
+20v DC