11
English
7. Turning on the projector
After having followed the preceding steps, proceed with the power supply and turn on the projector via the main power
switch. The display will show a short welcome message and the software version installed on the internal microproces-
sors:
INFINITY SPOT L
The projector will perform the reset function on all motors. This operation will last a few seconds, thus allowing the
digital control motors to correctly position themselves. Then the display will turn on in a fixed mode, indicating the
correct DMX 512 signal reception.
If the address continues to blink and the “NO DMX SIGNAL” message appears, it means that the DMX signal has not
been received. Check the connection cable and the mixer functioning.
7.1 DMX address of the projector
NB:
The following section is valid only in the case where Infinity Spot L is controlled by the signal DMX 512.
Each projector uses 28 address channels for its complete operation and is controlled by a DMX 512 signal (for further
information, see section 7.2, DMX functions).
When powered up initially, each projector will show A001, which indicates DMX address 001; a projector thus addres-
sed will respond to commands of channel 1 to 28 from your DMX 512 controller. A second unit must be addressed as
A029, a third as A057 and so on. The operation must be carried out every Infinity Spot L which has an address different
from A001.
Altering DMX address
1.
Press the + or – button until the display shows the required DMX address. The digits on the display will blink to indi-
cate that the variation has not been registered.
2.
Press the enter key to confirm your selection. The digits on the display panel will cease to blink and the projector will
now respond to the new address.
NB: by holding the + or – button down the scrolling will be faster; thus allowing a faster selection
WARNING!
If you alter the DMX address with no DMX signal connected, the digits on the display panel will continue to
flash even after you have pressed ENTER button to confirm the address.
During th reset the display will blink for a few secods..
.. then the DMX address screen will appear
