FOUR DIFFERENT WAYS OF CLEANING
Only using normal tap water
Put the item on the mesh screening, and then put the
mesh screening into the stainless steel tank. Keep the
item is immerged in the water, ensure the water is
above "MIN-" marking but does not exceed the "MAX-"
marking.
1
Put the item to be cleaned on the mesh screening, then
fill the water. Ensure the item is immerged in the water;
the water level should above the "MIN-" marking, but
does not exceed the"MAX-" marking. Put the plug and
press the "ON" button.
TURN ON THE HEATER, ENHANCE CLEANING:
Used to clean the polishing wax on the surface of semi finished rings, necklace etc.
If need reduce the time of heating, can put in
some warm water, but can't put in boiled water.
GENERAL CLEANING
Note:
On the cleaning, the dirt appeared from the
item, just looks like "smoking", meanwhile, the
clean water changed to be dirty. When there is no
"Smoking" appeared, the item is clean now, no need
to clean more times. (Usually in 180s is enough).
If the water is dirty, change the dirty water with
clean water, go on cleaning another item.
Press the "TC" button, the heater is working, around 40
minutes later, the temperature of the water is about 65℃,
the heater will auto shut off.
Press "SET" button, choose one circle from 280/380/480S, then press "ON" button, the
unit start to work.
Note:
Using 65
℃
warm water, it can melt the polishing wax on the surface of the item, it also
can soft the oiled dirt, therefore, can enhance cleaning.
7
2
REGARDING 5 DIGITAL TIME CHOOSING
It will automatically display 180S when power at the first time,
It is the most common cleaning time. Pressing ON, it begins
cleaning. The time displayed is the time left. When the time
"
000
" is displayed, the unit will automatically stop.
Pressing SET, there is a new time displayed, every time press
SET, it will change to the next time display. It usually use for
the first time cleaning of the product, the dirt staying on the
product is long, so it needs more time to clean.
It usually use for the first time cleaning of several products
together. Choosing this for shorten the cleaning process.
It usually use for cleaning the greasy valve, greasy gear,
greasy bearing and such as these metal parts, when choosing
this time, using the heater together. This function can soften
the oils to increase the cleaning result.
There still has dirt likes smoke come out when it closes to
finish the 180s cleaning. Using this step.
This step is usually taken after finishing the above steps, but
the water in tank is dirty, replacing with clean water and then
cleaning another 90s to keep clean of the product's surface.
Long time cleaning may cause the original unfirm screw
on the product, the original unfirm inlaid product become
loosen.
6
Summary of Contents for CD-4820
Page 14: ......
