Page 3 of 3
Part number 45027
|
Revision 1.1
|
Effective 17APR2020
© 2020 Codex DNA, Inc. All rights reserved.
14. Connect the system to a grounded power outlet.
15. Switch the power on at the power inlet.
16. The system will boot up, perform a self check, and present
the BioXp™ 3200 home screen.
17. The system is now ready to use.
18. It is recommended that you run a QC job to ensure the
system is operating properly. Contact Codex customer
service if one is required.
Re-crating a BioXp™ 3200 system for shipping
Note that the lower crate is not symmetrical and the BioXp™
system must be placed with the display in the corner with no
foam as (shown in figure 4).
Figure 4: Correct orientation
1. Place the plastic bag into the crate facing up with the
bottom pushed into the four corners of the foam supports.
2. Using two people, place the BioXp™ system into the
shipping crate as shown in Figure 5.
Figure 5: Lowering the BioXp™ system into the crate
3. Wrap the bag over the instrument and tape the open end
down over the unit such that water cannot enter the bag
from the top.
4. Place the upper foam support on the unit.
5. Place any accessories needed into the accessory box and
place the accessory box on the side of the unit.
Place the sides back onto the crate, latch all lower latches,
and remove the top portion.
Figure 6: Placing the crate lid onto the base
6. If removed, place the lid back on the crate and lock all
of the latches. Use small wire ties through each latch to
secure them.
7. Contact Codex customer service for shipping information:
|
855.474.4362
8. Once bill of lading has been sent please attach it to the
top of the unit and bring to your shipping dock for pickup.
