Tools Required
• Philips screwdriver
2
3
Check the contents of the box are correct
Box Contents
1
Front Plate
2
Lever Handles x 2
3
Inside Lever Boss
4
S Spacer
5
Front Patch Fitting (LH
or RH)
6
2 Piece Internal Latch Patch fitting (with Gasket)
7
Batteries x 4 `N cell`
8
Front Plate Cylinder Keys
9
Through Fixing Allen bolts x 2
10
Patch Fixing Allen bolts x 2 (short)
11
Internal Patch Steel Cover Plate
12
Strike Plate
13
Allen Keys
14
Front Plate Cylinder Cover
15
Classroom Function Tailpiece
This box should also contain Programming and
Operating Instructions.
4
You should familiarise yourself with the lock
and its operation before attempting to fit. Locks
are supplied as either RH or LH versions check
you have the correct product to suit the hand
of your door. Illustration page 5 shows RH
version.
1. With digital lock face down on a bench remove the
transit strip from the rear of the lock by removing the
two transit screws.
2. Install batteries into lock ensuring that the positive
and negative ends are correctly orientated.
3. Ensure that the clutch below the battery holder is
in the correct position with orange and black cable
exiting the top left of the clutch. If not rotate into the
correct position.
4. Fit the front patch fitting to the frontplate with the
two short transit bolts and tighten.
Note – ensure cables are not trapped.
5. Test the factory master code by pressing 1234.
The blue light should signal to show a correct code.
The red light will signal after 5 seconds to show the
code operation period has expired.
6. Fit the lever handle to the frontplate boss
according to the hand of your door and secure with
grub screw.
7. Remove the steel coverplate from the latch patch
fitting by unthreading the Nylon nut.
8. Ensure that the latch patch fitting is handed
to suit your door. The hand can be changed by a
combination of reversing the latch head (via the
securing screw) and/or by turning the latch patch
fitting 180 degrees.
9. The spindle supplied is suitable for glass
doors up to 15mm (
9
/
16
”) thick. For doors thicker
than 15mm (
9
/
16
”) please install the spacer piece
provided onto the long end of the spindle.
Now take the internal latch patch fitting and pass
INSTALLATION OF GLASS DOOR LOCK
the spindle through the latch follower with the short
end facing the code side. Push the spindle through
until the washer rests against the patch lock.
10. Place the thin plastic gasket on the latch patch
fitting so it is seated against the glass door and latch
when assembled.
11. Holding latch patch fitting in place take the
frontplate assembly and fit over spindle.
12. Using the 2 through fixing bolts from the latch
side secure the code side and latch side together,
ensuring the lock is aligned vertically and horizontally
with the door.
13. Refit the steel coverplate to the latch patch fitting
and secure with Nylon nut.
14. Take the internal lever boss and fit, pushing
firmly onto spindle. Secure with grub screw.
15. Fit internal lever onto boss according to hand of
door and secure with grub screw.
Operation Check
A) Enter the mastercode wait for the blue light and
depress the lever which should retract the latch.
After the red light depress the lever once more which
should not retract the latch.
B) Depress the internal lever which should retract
the latch.
If A) or B) do not work please check installation from
step 12 and that lock has not been set in passage
function by key (see programming instructions).
NOW - Change factory set Mastercode
(see programming instructions).
