Ver:1.1
s4 series user’s manual
37
5.2.3 Print Setup
Parameter Explanation
Default
Transfer mode
Change the printing mode
This setting could change the printing mode
Selection: By Command, Direct thermal, Thermal
Transfer
By command
Print mode
Select the print mode
This setting changes the label delivery mode.
Selection: Normal, Tear off, Peel off, cut
Normal
Speed
Adjust the printing speed
This setting could change the printing speed
Selection: 1, 2, 3, 4 dpi
3
Darkness
Adjust print darkness
This setting could adjust the printing quality by the
printing heat
Selection: 0~15
8
Label type
Select the label type
This setting could select the media.
Selection: Gap/Notch, Mark, continuous
Gap/Notch
Label sensor
Change the label sensor type
This setting could change the convenient sensor
type to detect the label.
Selection: By command, see-through, reflective
By command
Print width
Adjust the print width
This setting determines the printable area by
setting the printing dot.
Selection: 120~832 dot
832 dot
Print X offs
Adjust the horizontal origin of coordinate
Selection: -80~+80 dot
00
Print Y offs
Adjust the vertical origin of coordinate
Selection: -80~+80 dot
00
TPH Y offs
Adjust the print head vertical offset
Selection: -120~+120 dot
000
Back Y offs
Set the label stop position
Selection: -080~+120 dot
000
All manuals and user guides at all-guides.com
