Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-149-B
page 13 of 33
CB 2 Series
Administrator Guide
4.2 CB 2-e with Public Address Installation Instructions
Pre-Installation
Electrical preparation
– The unit may have supply wires run either behind the unit through the wall
or below the unit by using an external conduit through the bottom of the unit. Holes in the back and
the bottom of the unit have been provided for this purpose.
Installation Procedures
1. Remove the top of the unit.
2. Mark the mounting holes
– In order to comply with the Americans with Disabilities Act
(ADA) of 1990, the speakerphone button(s) should be positioned between 34 and 48 inches
from grade level. (Consult an ADA specialist in your area to verify local and federal
guidelines.)
3. Drill all marked holes.
4. Install the housing
– Four anchors of appropriate size and type should be used to
fasten the housing to the wall.
IMPORTANT:
If wiring is being supplied from the back, ensure that the conduit is aligned at
this time.
5. Reattach the top.
Wiring
1. Ground
– The ground (green) wire should be stripped and fastened to the supplied
grounding lug.
2. 12-24V AC / DC
- The enclosure comes pre-wired, except for incoming power. Bring
incoming power to the harness or pigtails.
A Certified Electrician should do any wiring.
120V AC
– The enclosure comes pre-wired except for incoming power. If you are using a
Code Blue Power Supply/Transformer please look at the wiring diagram on top of
the Step-Down Transformer to verify how to step down the voltage that you are bringing
to the enclosure.
A Certified Electrician should do any wiring.
Communications Wiring
Have category 3 or higher 4 pair cable terminated to a RJ45 applying TIA/EIA T568-B specifications.
