5
Using Your Remote Transmitter (cont.)
Valet Mode
Valet mode, sometimes referred to as “keyless mode”, when engaged prevents the
security system from arming - automatically or via the remote control transmitter -
while allowing the convenience features (remote control door lock, unlock and
trunk) to remain functional. Valet mode is useful when leaving your vehicle for
service or any time you do not what your vehicle to be armed inadvertently.
To engage the valet mode:
1.
Turn key to the ON or RUN position.
2.
Press the ARM button on the remote transmitter.
The status indicator will begin
blinking a double flash pattern to confirm security system is in valet mode
and continue to double flash until the status indicator is disengaged.
To disengage valet mode and return your system to the normal operating mode:
1.
Turn the key to the ON or RUN position.
2.
Press DISARM button on remote control transmitter.
Status indicator will turn off.
To prevent your system from arming just one time without engaging valet mode,
simply press the disarm button on your remote control transmitter after turning the
ignition key off. This is useful when unloading your vehicle or anytime when you do
not want your system to arm automatically but will want to arm the system without re-
entering the vehicle.
Hint: When doing so, remember to arm the system with your remote control.
Sensor Override
Your security system is equipped with an impact detector, which causes the
system to emit a warning chirp for a light nonthreatning impact or alarm cycle upon
harder impact to the vehicle. It may be necessary at times to temporarily disable the
sensor feature, especially in areas where severe vibration can cause false alarms.
• Press button 1 & 2 together. The system will respond with three (3) chirps and
three light flashes, indicating that the system is armed with the sensor disabled.
This procedure disables the sensor for only one arm/disarm cycle. The sensor will
be enabled the next time the alarm system is armed.
Activating the Trunk Release Output
To activate the Trunk Release output, press and hold the DISARM button. The
security system will disarm if it is armed, and the vehicle trunk / hatch will open.
Personal Protection (Panic) Alarm
Pressing the panic button on the remote transmitter activates the Panic feature,
sounding the siren and flashing the parking lights. Panic is designed to bring
attention to the vehicle and surrounding area, warding off a would-be intruder. Press
the panic button again to turn off the Panic alarm.
