4
Using Your Remote Transmitter
The remote transmitters included with your security system are high-quality, durable
instruments. Each transmitter has a moisture-resistant case and sealed rubber
buttons to protect the internal circuitry and 12-volt alkaline battery. Also, each
transmitter utilizes Rolling Code technology to deter code-grabbing devices. Your
security system has the ability to operate from up to four (4) remote transmitters.
Arming the Security System
To arm the system, exit the vehicle, close
all doors, then press and release the ARM
button. The parking lights will flash twice
and doors will lock (if equipped and
connected), indicating the system is
armed. The status indicator will turn on
and blink steadily, once per second.
If you press the ARM button again within 5
seconds the siren will chirp twice.
If the parking lights flash only once, this
indicates that the system has detected
that the vehicle courtesy light is on, or that
an entrance is not closed securely. Check
to see that all vehicle entrances are
closed securely. Once all entrances are
secured (and the courtesy light is off), the
system will chirp / flash again. The system
is now fully armed. If all entrances are not
secure the system will arm itself after 4
minutes.
ARM
DISARM
TRUNK
PANIC
Press to Arm the
Security System
Press BOTH BUTTONS
for Sensor Override
Press to Disarm the
Security System
Press and Hold
to Activate
Trunk Release
Disarming the Security System
To disarm the system, press and release
the DISARM button. The parking lights
will flash once, and the doors will unlock
(if equipped and connected). The
courtesy light will turn on for 1 minute, or
until the vehicle is started. If you press
disarm again within 5 seconds, the siren
will chirp once.
Trip Identification
If the siren chirps four times when
disarming, this indicates that the system
was triggered in your absence. (The
status indicator will also flash rapidly.)
Perform the following operation to
determine the protected zone that
triggered the system:
• After disarming, press the Override
button. The siren will chirp to indicate the
cause of the alarm trigger:
1 chirp
Shock Sensor
2 chirps
Other Sensor
3 chirps
Door or other Entrance
4 chirps
Ignition was turned on
