Code Alarm PowerCode PC 6100, Owner'S Manual, Page: 7 / 12

7
Adding Remote Controls to Your System
The Power Code PC 6100 TM has the ability to operate from up to four
(4) remote controls. Follow these instructions to add a remote control
to your system.
1. Make sure the system is disarmed and the ignition is off.
2. Open the driver’s door.
3. Turn vehicle ignition on.
4. Press and hold emergency override button.
After 15 seconds, the horn will sound three (3) times. This
indicates that the unit has entered the remote control
programming mode.
5. Release the button.
6. Press the LOCK button (button 1) on the remote control to be
programmed.
The horn will sound once, indicating that the system has
“learned” that remote control.
7. Repeat step 6 for any additional remote controls.
8. Turn the vehicle ignition off to exit the programming mode.
Test all remote controls to ensure that they work properly.
Deleting Lost or Stolen Remote Controls from Your System
If one of your remote controls is lost or stolen, follow these instructions
IMMEDIATELY to remove the control code from your system.
1. Make sure that you have all remaining remote controls
available.
2. Enter the control programming mode by following steps 1 - 5
of
Adding Remote Controls to Your System .
3a. If you have only one remaining remote control, press the
LOCK button on that remote control four (4) times, pausing
at least 1 second between each press. Make sure that the
horn “honks” each time you press the LOCK button.
3b. If you have two remaining remote controls, press the LOCK
button on each remote control two (2) times, pausing at least
1 second between each press. Make sure that the horn
“honks” each time you press the LOCK button.
3c. If you have three remaining remote controls, press the
LOCK button on the two remote controls one (1) time, then
press the LOCK button on the remaining remote control
twice. Pause at least 1 second in between each press. The
horn must “honk” each time you press the LOCK button.
4. Turn the vehicle ignition off to exit the programming mode.
When you are finished, the lost or stolen remote control will
no longer operate your system.
System Maintenance