11
A. System Power-Up
1. All connections must be secure and well insulated.
2. Insert fuses inside of the control module in their respective slots.
3. Plug in DNA/fuse cover on top of the control module.
4. Turn vehicle ignition on.
5. Plug in 24-pin Basic Harness.
6. Press DISARM on the remote control
7. Turn vehicle ignition off.
B. Remote Transmitter Programming
Note: Each system module has two “slots”, or memory locations, to
store transmitter codes, giving it the ability to operate from up to
two transmitters. For proper operation, a transmitter code must be
stored into each memory slot. When using less than two
transmitters, follow the suggested programming parameters:
• One Remote Transmitter - Program two (2) times
• Two Remote Transmitters - Program each transmitter once
1. Open the driver’s door.
1a. The 20/B wire must initially see a negative input to
access programming.
2. Turn vehicle ignition on.
3. Press and hold emergency override button.
After 10 seconds, the siren or horn will sound three (3) times. This
indicates that the unit has entered the transmitter programming mode.
4. Release the button.
5. Press the Arm button on the remote transmitter to be programmed.
The siren or horn will sound once, indicating that the system has
“learned” that remote transmitter.
6. Repeat step 5 for any additional transmitters or transmitter codes.
7. To continue to the Options Programming mode, go to step 2 of
Programming Selectable Options (below). Otherwise, turn the
vehicle ignition off to exit the programming mode. Test all remote
transmitters to ensure that they work properly by toggling the ARM
and DISARM buttons.
C. Programming Selectable Options
Note: Transmitters must be programmed prior to these steps.
1. Repeat steps 1-4 of Remote Transmitter Programming (above).
2. Press and release the emergency override button.
The horn or siren will sound four (4) times. This indicates that the
unit has entered the Keyless & Alarm Options Programming mode.
3. Press the PANIC button to advance to the next feature.
The siren or horn will sound a number of times to indicate the
number of the option.
2. System Power-Up and Programming
