6
Automatic Convenience Options
The F10/F15 performs a variety of automatic functions to enhance
security and comfort. Some of these features are programmable at the
time of installation. Please see your installer for further details.
Automatic Arming
The F10/F15 will arm automatically (if this option is selected) 1 minute
after the ignition is turned off. This feature can be temporarily disabled
by placing the system into Valet mode.
Ignition Lock
If all doors are closed and the vehicle is started with the key, the doors
will automatically lock.
Ignition Unlock
The doors will automatically unlock when the ignition is turned off.
When Your Security System is Triggered
The F10/F15 will trigger if one of the following events occurs while the
system is armed:
• Any protected entrance is opened
• The vehicle ignition is turned on
• The vehicle is jolted hard enough to signal the impact detector
Once the alarm is triggered, the horn sounds and the vehicle
parking lights flash for 30 seconds. The system will then re-arm,
awaiting the next intrusion attempt. To stop the horn while
keeping the alarm armed and doors locked: press the ARM
button while the system is triggered.
The Interior Status Indicator
The Status Indicator is a high-intensity red light mounted in a visible
location on the vehicle dashboard. This red light gives a visual
indication of the alarm system’s state of operation. Note the chart
below:
If the Status Indicator is...
....then the Security System
Off
is disarmed
Flashing Slowly
is armed
Flashing Very Quickly
was triggered in your absence
(see Attempted Intrusion ID - page 4)
Flashing Intermittently
is in Valet mode
(2 flashes, off, 2 flashes)
On (not flashing)
is in Pre-arm mode
11
Programming Selectable Options
Note: Transmitters must be programmed prior to these steps.
1. Repeat steps 1-4 of Adding Remote Controls to Your System (page 7).
2. Press and release the emergency override button.
The horn or siren will sound four (4) times. This indicates that the
unit has entered the Keyless & Alarm Options Programming
mode.
3. Press the PANIC button to advance to the next feature.
The siren or horn will sound a number of times to indicate the
number of the option.
RESET
Press BOTH
butons to
advance to
next feature
ARM
Press to
turn feature
on or off
DISARM
Press to reset
all options to
factory defaults
4. Press the Arm button to turn the option on or off.
The vehicle status indicator on the dashboard indicates whether
an option is on or off.
• If the selected option is ON, the indicator will light.
• If the selected option is OFF, the indicator will
turn off.
• The status indicator will turn on or off when an option is changed.
5. When changes are complete, press and release the emergency
override button to continue to the next option bank. (Siren or horn
will sound five (5) times.)
6. To reset all options back to factory defaults, press the DISARM button.
Note: Option Bank Installer options will never reset.
7. Turn ignition off to exit programming.
See Options Chart on page 13.
