Using Your Remote Control
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the LOCK
icon button on the remote control. The system will sound twice and the
parking lights will flash twice, indicating the system is armed. The doors will
also lock at this time (if equipped and connected). The blue dash mounted
status indicator light will blink steadily, once per second. To arm the system
silently, press and hold the LOCK icon button for 2 seconds. The parking lights
will flash 2 times indicating the system is armed and has locked the doors (if
equipped and connected). The blue dash mounted status indicator light will
blink steadily, once per second.
Pre-arm Mode
If the system sounds and the parking lights flash only once, this indicates that the
vehicle’s interior light is on or an entrance is left open. Check to see that all doors
hood and trunk are closed properly. Once all entrances are secured (and the
interior light is off), this system will sound/flash again. The system is now fully
armed (If the entrance is not secured within 4 minutes, the system will arm and
ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system press the UNLOCK icon button. The system will sound and
the parking lights will flash once, and the doors will unlock (if equipped and
connected). To disarm the system silently, press and hold the UNLOCK icon button for 2 seconds. The
parking lights will flash, indicating the system is disarmed and the doors will unlocked (if equipped and
connected).
Disabling/Enabling Confirmation Chirps
1. Turn the ignition key ON then OFF.
2. Within 10 seconds push and release the valet/override button 3 times.
3. The system will sound 2 times to disable confirmation chirps or 1 time to enable confirmation
chirps.
.
Attempted Intrusion Identification
This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If
an intrusion attempt occurred, the system will sound 4 times and the parking lights will flash 3 times
when disarming the system. Enter the vehicle an observe the blue dash mounted status indicator light
to Identify which zone was triggered.
1. IT-s Interior Theft Sensor- 1 flash, pause 1 flash, etc.
2. Hood or Trunk Pin switch- 2 flashes, pause 2 flashes, etc.
3. Door Entry- 3 flashes, pause 3 flashes, etc.
The intrusion warning indicators are stored in the system’s memory and will be erased when the ignition
key is turned on.
Two Stage Door Unlock (Optional)
If this feature is enabled on your system, pressing the UNLOCK icon button one time on the remote
control will unlock only the driver’s door. Press the UNLOCK icon button again to unlock the remaining
doors.
Activating the Trunk Release Feature (Optional)
If this feature is enabled on your system, pressing and holding the TRUNK icon button on the remote
control for 2 seconds will open the vehicle’s trunk or hatch.
*Throughout this manual, ‘press’ refers to pressing for less than 1 second.
3
Summary of Contents for CA-160
Page 6: ...LCD Remote Control Functions 6 TRUNK TRUNK ...
Page 12: ......
