4
WARNING!
Installation
All devices should be mounted in accordance with the manufacturer's instructions and
securely fasten to vehicle elements of sufficient strength to withstand the forces applied to
the device. Driver and/or passenger air bags (SRS) will affect the way equipment should
be mounted. This device should be mounted by permanent installation and within the
zones specified by the vehicle manufacturer, if any. Any device mounted in the deployment
area of an air bag will damage or reduce the effectiveness of the air bag and may damage
or dislodge the device. Installer must be sure that this device, its mounting hardware and
electrical supply wiring does not interfere with the air bag or the SRS wiring or sensors.
Front or rear grille/bumper placement must avoid interference with SRS sensors. Mounting
the unit inside the vehicle by a method other than the permanent installation is not recom-
mended as unit may become dislodged during swerving, sudden braking, or collision.
Failure to follow instructions can result in personal injury.
WARNING!
!
B H G 1 2 3 4 5 6 PANEL
+ + GND LIGHTS
BATT.
F1 F2 F3 F4 F5 F6
+ BATTERY 40A 20A 20A 20A 20A 20A
BACK LIGHTING
WIRING DIAGRAM
FIGURE 3
To install the Switch Box follow the installation instructions. There are several ways you may install this unit,
but if it is installed with the TSD trunion mounting bracket, you will need to follow the instructions provided for
the "CO" series brackets.
If you choose to mount this unit by a bail bracket (not provided), then follow the instructions that come with our
bail brackets.
The Switch Box may be mounted on top of or below a siren system. If this is your choice, then follow
the instructions below:
1) Select a mounting location which allows the vehicle and all controls to be
operated safely under all driving conditions.
2) Choose an adequately ventilated area. Never install near heat ducts or totally
enclosed areas.
3) Arrange the bottom of the switch control unit so that it is even with the siren face
module. Fasten the two units together with trunion mounts or brackets (not provided)
from both sides. You may need to remove the switch control for the housing. If this is
the case, it will require the removal of four phillips head screws located on top of the
switch control housing.
4) Secure the case with 1/4" - 20 x 5/8" hex head screws and 1/4" split lockwasher
(provided in kit). Do not tighten securely until a proper angle is positioned for safe
operator visibility.
Summary of Contents for ROCKERPAK430
Page 7: ...7 NOTES ...
