920-0655-00 Rev B
Page 2 of 8
PURSUIT SIREN
INSTALLATION & MOUNTING
Before installation, examine the equipment for transit damage. Do not use damaged or broken parts.
Before any installation work is carried out, plan where the various components will be mounted and what route
the wiring will take. The siren can be mounted by screwing it into any flat surface using the 4 x
supplied screws,
preferably with a drip loop so it is not possible for water to run down the cables into the unit.
THE SIREN IS NOT WATERPROOF, IT MUST BE MOUNTED WITHIN
THE VEHICLE CABIN.
Suggested mounting locations include the boot, under passenger seat or passenger footwell area.
Do not install and/or operate this safety product unless you have read and understand the
safety information contained in this manual.
1. Proper installation combined with operator training
in the use, care, and maintenance of emergency
warning devices are essential to ensure the safety
of you and those you are seeking to protect.
2. Exercise caution when working with live electrical
connections.
3. This product must be properly grounded.
Inadequate grounding and/or shorting of electrical
connections can cause high current arcing, which
can cause personal injury and/or severe vehicle
damage, including fire.
4. Proper placement and installation are vital to the
performance of this warning device. Install this
product so that output performance of the system
is maximised and the controls are placed within
convenient reach of the operator so that s/he can
operate the system without losing eye contact with
the roadway.
5. It is the responsibility of the vehicle operator to
ensure during use that all features of this product
work correctly. In use, the vehicle operator should
ensure the projection of the warning signal is not
blocked by vehicle components (i.e., open trunks
or compartment doors), people, vehicles or other
obstructions.
6. The use of this or any other warning device
does not ensure all drivers can or will observe or
react to a warning signal. Never take the right-
of-way for granted. It is your responsibility to be
sure you can proceed safely before entering an
intersection, driving against traffic, responding at a
high rate of speed, or walking on or around traffic
lanes.
7. This equipment is intended for use by authorized
personnel only. The user is responsible for
understanding and obeying all laws regarding
warning signal devices. Therefore, the user
should check all applicable city, state, and federal
laws and regulations. The manufacturer assumes
no liability for any loss resulting from the use of
this warning device.
8. Keep your attention on the road. Don’t try to
operate or focus on any device while you’re
driving.
Important! This unit is a safety device and it must be connected to its own separate, fused power source to
assure its continued operation should any other electrical accessory fail.
Caution: When drilling into any vehicle surface, make sure the area is free from any electrical wires, fuel lines,
vehicle upholstery, etc. that could be damaged.
