1 6
A. REPLACE
M I C R O P H O N E
B. REFER TO SETUP
AND ADJUSTMENT
S E C T I O N
C. PLUG MICROPHONE
IN SECURELY
D. CHECK WIRING
E. CALL PSE FOR LIST
OF ADAPTABLE
M I C R O P H O N E S
P R O B L E M
PROBABLE CAUSE
R E M E D Y
NO SIREN OUTPUT.
EXTERNAL 20A
FUSE BLOWS.
A. AMPLIFIER POWER WIRES
REVERSED POLARITY
NO OUTPUT FROM
SPEAKER, TONES
HEARD INSIDE
AMP. MODULE.
A. SPEAKER NOT CONNECTED/
OPEN CIRCUIT IN SPEAKER
W I R I N G
B. DEFECTIVE SPEAKERS
SIREN TONES
VOLUME TOO
L O W / G A R B L E D .
A. LOW VOLTAGE TO SIREN
A M P L I F I E R
B. HIGH RESISTANCE IN WIRING/
DEFECTIVE SPEAKER
C. SPEAKERS PHASED
I M P R O P E R L Y
A. SHIFT VEHICLE OUT
OF PARK.
B. SELECT PROPER
SIRENLOCK LEVEL
C. CHECK
C O N N E C T I O N S
A. CHECK POLARITY
B. REPLACE
S P E A K E R ( S )
A. CHECK SPEAKER
W I R I N G
B. REPLACE
S P E A K E R ( S )
A. CHECK WIRING FOR
BAD CONNECTIONS/
CHECK VEHICLE
CHARGING SYSTEM
B. CHECK SPEAKER(S)
W I R I N G / R E P L A C E
S P E A K E R ( S )
C. REFER TO PAGE 5
FOR PROPER PHASING
(200W OPTION)
HIGH RATE OF
SPEAKER FAILURE.
A. HIGH VOLTAGE TO SIREN
B. 58 WATT SPEAKER CONNECTED
TO 100 WATT TAP. 58 WATT NOT
A L L O W E D .
A. CHECK VEHICLE
CHARGING SYSTEM
B. USE CORRECT
S P E A K E R
SIREN CONTINUES
TO OPERATE FOR
7 SEC. AFTER
MANUAL BUTTON/
HORN RING IS
R E L E A S E D .
A. "HIT-N-GO" FEATURE ENGAGED.
NORMAL OPERATION
INTERCLEAR WILL NOT
POWER AUXILIARY
D E V I C E S .
A. THERE IS A SHORT IN THE
WIRING, OR THE LOAD IS
GREATER THAN 1 A.
A. CHECK FOR
SHORTS. INSTALL
I N T E R C L E A R
BOOSTER KIT (PART
# I N T B S )
P.A. VOLUME LOW OR
NO P.A. AT ALL.
VOLUME CONTROL
FULLY CLOCKWISE.
A. DEFECTIVE MICROPHONE
B. MAXIMUM P.A. VOLUME
TRIMMER MISADJUSTED. SEE
SETUP AND ADJUSTMENT
S E C T I O N .
C. MICROPHONE NOT
COMPLETELY PLUGGED IN.
D. COMMON MICROPHONE
CIRCUIT NOT PROPERLY WIRED.
E. INCORRECT MICROPHONE.
T R O U B L E S H O O T I N G
(Refer to wiring diagram page 15)
A. PARK KILL ACTIVATED
B. SIRENLOCK ENGAGED
C. SHORTED SPEAKER OR
SPEAKER WIRES. SIREN IN
OVER CURRENT PROTECTION
M O D E .
