Codan 4908-MINIBUC, Installation Manual

Page: 2 / 28

Ku-Band BUC systems
Page 2 of 18 12-50176-EN Issue 2, December 2010
Unpacking the equipment
On receiving your BUC system, check the contents against the packing list. Make sure
that all equipment itemised on the packing list is present and that there is no damage to
the equipment before you start installing the equipment.
If anything is missing or damaged, please contact your nearest Codan office immediately
to obtain the correct warranty service procedures. This ensures prompt assistance,
minimal turnaround time, and avoids any freight issues.
We recommend that the equipment is installed by qualified and experienced personnel,
to the relevant standards and approvals.
Installing the BUC equipment
For information on electromagnetic compatibility requirements and safety notices,
please see the reference manual for the product.
WARNING
All equipment that is mounted outdoors must be adequately
weatherproofed.
Use self-amalgamating tape to seal connectors and cable entry points,
from the connector to the cable sheath (see
Application Note: Sealing
N-type and MS connectors in satellite equipment installations , 17-60094).
Ensure all W/G joints are properly sealed with the appropriate gasket (see
Application Note: Waveguide gasket kits , 17-60128).
CAUTION
Water is the most common cause of poor performance in VSAT
installations. Ensure that all cables and W/G junctions are properly sealed.
WARNING
A radiation hazard exists if the BUC is operated with its RF output
unterminated.
WARNING
The BUC must be installed in a restricted access location with appropriate
warning signs displayed.
CAUTION
Codan disclaims any liability or responsibility for the results of improper
or unsafe installation practices.