23
3.5 Remote control inputs (Ethernet)
The Ethernet link network connector allows you to access the LINUS14/14D from a host computer for remote control,
firmware update and downloading DSP presets. Please note that for setting up proper network connection you need to
use the CODA Audio LINUS Control software.
3.6 Power outputs
3.6.1 SPEAKON® Connection. Both SPEAKON® connectors are connected to the channel A and channel B amplifier outputs.
The pin configuration of the SPEAKON® connectors is as follows:
LINUS14/14D
3. INSTALLATION
SPEAKON®
Output 1
Pin 1 + Channel 1 amplifier output
Pin 1 - Channel 1 inverted
Pin 2 + Channel 2 amplifier output
Pin 2 - Channel 2 inverted
SPEAKON®
Output 2
Pin 1 + Channel 3 amplifier output
Pin 1 - Channel 3 inverted
Pin 2 + Channel 4 amplifier output
Pin 2 - Channel 4 inverted
SPEAKON®
Output 3
Pin 1 + Channel 1 amplifier output
Pin 1 - Channel 1 inverted
Pin 2 + Channel 2 amplifier output
Pin 2 - Channel 2 inverted
Pin 3 + Channel 3 amplifier output
Pin 3 - Channel 3 inverted
Pin 4 + Channel 4 amplifier output
Pin 4 - Channel 4 inverted
WARNING!
SPEAKON® connector marked with the lightning flashes indicate high voltages that are potentially life threatening.
Wiring to these terminals requires installation by an instructed person or the use of ready-made leads or cords.
Custom wiring should only be carried out by qualified personnel.
To prevent electric shock, do not operate the amplifier with any of the conductor portion of the speaker wire exposed.
NOTE:
For reasons of safety and performance do only use high-quality fully insulated speaker cables of stranded copper
wire. Use the largest wire size that is economically and physically practical. Make sure that the cables are not longer
than necessary.