21
AFTER SALES SUPPORT
1300 663 907
MODEL: HE170703
PRINTING AND REMOVING MODELS
4.2 Good 3D Printing Practices
Please refer to these steps during every print to ensure the best quality.
Before Printing
5.
Ensure your GCODE file is correctly setup, filament diameter is set to 1.75mm and correct
temperature settings for the material you are using. The ModelMaker prints PLA filament.
Depending on the type of PLA filament, temperatures can range from 180 to 210⁰C. If you are
unsure, start with 190⁰C
6.
Check all cables and connectors are connected and the printer is on a stable surface
7.
Check that Print Bed is level and approximately 0.1mm from the nozzle
8.
Check that the Print Bed is clean and dust free and nozzle does not have excess material stuck
to it
During Printing
1.
Closely monitor the first layer being printed – Most problems, like poor adhesion and
warping, will occur in the first layer. If problems occur, stop the 3D Printer in the menu or
power off the printer
2.
Do not leave the 3D Printer unattended while in operation
3.
Keep hands clear while machine is operating
After Printing
1.
Wait for the Extruder to cool down
2.
Carefully remove 3D Object. Never use the Scraper towards your body. Keep Scraper evenly
flat when scraping to avoid damaging the Print Bed. Damaged Print Beds / mats may affect
adhesion for future prints
3.
Store 3D printer in a clean, dry environment
Always check Print Mat
is clean and there is no
residual plastic
Always check all cords
are connected
Always check GCODE
file settings match
filament and printer
Always check Extruder
distance is 0.1mm
from Print Mat
Always check Print
Bed is level
Summary of Contents for HE170703
Page 1: ... MODELNUMBER HE170703 INSTRUCTIONMANUAL VERSION 1 ISSUED 04 08 17 ...
Page 2: ... ...
Page 38: ... ...
