EN
4.4.4. At the rear side insert the both tongue into other slots, (Fig. 18)
surface. (Fig. 21).
Important:
4.4.2. Press on the release button (part no.23) and separate the buckle tongue,
(part no.24 page 01). (Fig. 16)
Otherwise is not OK (Fig. 22).
Notice: Ambra child seat's harness have 2 height position, the top of the
shoulder belt must be parallel or a little higher than the child's shoulders. That
can provide the effective protect for your child at collision.
01) and pull back. (Fig. 15)
4.4.3. Insert the both tongue through the slots (Fig. 17)
5. Seat selection and adjustment
And must not at any time be fitted using only a 2-point lap belt. (Fig. 24).
5.2 Seat installation
If the car manufacturer allows child restraint systems on the passenger seat, the
seat should be moved to the position maximum back .(Fig. 25).
4.4.5. Then combine the two tongue belt and insert into the buckle housing (part
no.22 page 01) again to finish the adjustment. (Fig. 19,20)
Put the Ambra on the vehicle seat, and the child' face toward to the rear of
vehicle driving direction. ensures that the bottom surface of the seat is flat to the
vehicle seat surface and the front of Ambra just touch against vehicle backrest
We suggest always to install this child seat at the rear seat of the vehicle. This
will be more safety for your child.
Check if the vehicle buckle has interference with child seat, try to another seat.
(If this is the case will cannot fix the seat well). Please contact our customer
service department if you are in any doubt.
4.4.1. Relax the harness before adjust the height: One hand press down the
center adjuster button (part no.1O page 01) at the same time with the other
hand hold the shoulder belt (part no.03 page
Follow the step as bellow.
5.1 Adjusting the car seat 08
The child restraint system Ambra can be installed in vehicles on any seat
suitable for use in the listed vehicles fitted with 3-point with retractor safety-
belts, approved to ECE Regulation No. 16 or other equivalent standards. (Fig.
23).
Always using the rear seats of your vehicle even if your highway code permits
the use on the front seat. Check your highway code as this regulation may vary
according to the country.It is better to assemble your seat at side pavement.