Coccolle Mydo, User Manual, Page: 25 / 34

7. CARE AND MAINTENANCE
Periodically inspect your child seat for worn or damaged parts. If damaged parts
are found, replace the child seat. Keep the child seat clean. Do not lubricate any
parts of the child seat. To prolong the life of your nursery product, keep it clean
and do not leave it in direct sunlight for extended periods of time. Removable
fabric covers and trims may be cleaned using warm water with a household
soap or a mild detergent. Allow it to dry fully, preferably away from direct
sunlight.
First pull out the belt from the belt ALR. The diagonal belt will go through the
same side of belt guidance, while the lap belt will go through the same side of
belt guidance, then pull the diagonal belt and lap belt together through another
side of belt guidance.
NOTE: Keep the diagonal belt at the position of shoulder between the outside of
the neck and
shoulder( Middle of point A and B, see p26 picture a). Lock the tip
of the buckle into the vehicle seat buckle with a CLICK noise. Follow the
direction of arrow to tighten belt, and put redundant belt into cloth cover. Shake
the child safety car seat to make sure that it's securely attached. CAUTION! The
diagonal seat belt section must run diagonally backward. You can adjust the
course of the belt with your vehicle's adjustable belt deflector on both sides.
6.2.2.2 Installed in forward facing position with ISOFIX connector, belt and Top
Tether
Put the ISOFIX insert guide into the two ISOFX attachment points of your
vehicle. If you don't have ISOFIX insert guide, please ignore this step.
NOTE: The ISOFIX attachment points are located between the surface and the
backrest of the vehicle seat. Press the ISOFIX button to pull out the two locking
arms from the base bottom. Pull the locking arm to and fro until you hear an
audible CLICK which indicates they are fully engaged. And on both sides of the
locking arm's button turn into green safety color. Pull out the top tether and
press the release button, pull the top tether long enough to hang the latch on the
back of the car seat.
Fix the latch on the fixed point,and the position of the fixed point are shown in
the picture (one of the three positions). Make sure the top tether clip is tightened
up. First pull out the belt from the belt ALR. Diagonal belt through the same side
of belt guidance , lap belt through the same side of belt guidance, then pull the
diagonal belt and lap belt together through another side of belt guidance .
NOTE: Keep the diagonal belt at the position of shoulder between the outside of
the neck and shoulder( Middle of point A and B, see p27 picture a). Lock the tip
of the buckle into the vehicle seat buckle with a CLICK noise. Follow the
direction of arrow to tighten belt, and put redundant belt into cloth cover. Shake
the child safety car seat to make sure it is securely attached.
CAUTION! The diagonal seat belt section must run diagonally backward. You
can adjust the course of the belt with your vehicle's adjustable belt deflector on
both sides.
EN