Coccolle Mydo, User Manual, Page: 24 / 34

NOTE: The ISOFIX attachment points are located between the surface and the
backrest of the vehicle seat. Press the ISOFIX button to pull out the two locking
arms from the base bottom. Pull the locking arm to and fro until you hear an
audible CLICK which indicates they are fully engaged. Check that on both sides
of the locking arms the button turns into green safety color. Pull out the top
tether,and press the release button, pull the top tether long enough to hang the
latch on the back of the car seat. Fix the latch on the fixed point,and the position
of the fixed point are shown in the picture (one of the three positions). Make
sure the top tether clip is tightened.
6.2 Installed in Forward facing position
6.2.1.1 Installation in forward facing position with belt or belt and ISOFIX
connector
6.2.1 Group I (9-18kg)
6.2.2.1 Installed in forward facing position with ISOFIX connector and belt or
only belt
Put the ISOFIX insert guide into the two ISOFIX attachment points of your
vehicle. If you don't have ISOFIX insert guide, please ignore this step. NOTE:
The ISOFIX attachment points are located between the surface and the
backrest of the vehicle seat. Press the ISOFIX button to pull out the two locking
arms from the base bottom. Pull the locking arm to and from until you hear an
audible CLICK which indicates they are fully engaged. And on both sides of the
locking arm's button turn into green safety color. At this time, you can push it as
far as possible into the back of car seat. Pull out the belt from belt ALR slowly.
Shoulder belts pass through the gap between the headrest and the seat back,
one
side of diagonal belt through the backrest and Belt Guidance. Another Side
along upper inside. Lap belt pass through Belt Guidance on both sides. Using
your knee to press down on the child seat,
tighten the vehicle seat belt as
follows: Pull on the lower part of the diagonal seat belt section near the vehicle
seat buckle to tighten the lap belt section. Note: The path should between the
headrest, the sleeping pad and the back of the seat. The path should between
the sleeping pad and
the cover of the seat (see p23 picture a).
NOTE: When you use this safety car seat in group 2,3 please remove the 5-
point harness, refering to
Chapter 5.7. Place the child seat forward facing on the
vehicle seat (in the direction of travel). Put the ISOFIX insert guide into the two
ISOFIX attachment points of your vehicle. If you don't have ISOFIX insert guide,
please Ignore this step. NOTE: The ISOFIX attachment points are located
between the surface and the backrest of the vehicle seat. Press the ISOFIX
button to pull out the two locking
arms from the base bottom. Pull the locking
arm to and from until you hear an audible CLICK which indicates they are fully
engaged. And on both sides of the locking arms' button turn into green safety
color (see p22 picture a).
6.2.2 Group II III(15-36kg)
EN