HANDSET AND BASIC DISPLAYS
The Headset Jack
The headset jack is located on the side of the handset and is a
standard 2.5mm plug. Simply plug the headset into the jack and the
headset will be active.
Note:
When the headset is plugged into the telephone, the
microphone and earpiece on the handset are not active.
Belt-Clip
Be sure to remove the belt-clip filler cap prior to installing Belt-clip.
Install the belt-clip as shown.
To remove the belt-clip, squeeze the release at the top of the clip
where it attaches to the phone, and gently Pull the clip up and out of
the handset.
Basic Displays
Hea ds et Idl e
Off-ho o k
Call T imer
New C ID R eceived
Volume Contro l
HANDSET AND BASIC DISPLAYS
Belt Clip
HEADSET Jack
To install the 3.6V 600mAh cordless handset battery pack:
1.Slide open the battery compartment door on the back of the handset.
2.Plug the battery connector into the 2-pin connector in the battery
compartment, and then insert the battery.
3. Close the battery compartment door.
4. Place the handset on the base unit cradle.
5. Once you have installed the battery pack and placed The handset on the
base you will hear a tone indicating The handset has connected with the
base and will successfully charge.
6.
Charge the battery pack for at least 12 hours before using
the handset the first time.
7. The
LED on the base illuminates when the handset is properly
making contact with the charge terminals.
A fully charged battery lasts for approximately:
5 hours when you use the handset continuously (talk time).
5 days when the handset is not in use (standby).
The display will show
If the battery lasts only a few minutes even after a full charge, the usable life of the
battery
has expired and needs to be replaced. Replacement batteries can be purchase in every
supermarket
or you can contact COBY ELECTRONICS CORP. customer service dept for
information about how to order a new batter
IMPORTANT:
CHARGE
Battery Duration
When the Battery Needs Charging
"LOW BATTERY".
When to Purchase a New Battery pack
,
y.
·
·
·
BATTERY INSTALLATION
15
16
Making Calls
Receiving Calls
When you hear the phone ring:
1. Pick up the handset from
the base and press
.
2. Wait until you hear a dial tone, and then dial the number You wish to dial.
3. When you are finished talking, press the
key or place the unit back into the base to
end the call.
Note: The IN USE CHARGE light on the base will illuminate when the line is active.
1. If the handset is in the base, lift the handset from the base. The handset will turn on.
There is no need to push the
key if the unit is on the base when the call comes in.
This auto-answer feature can be programmed off (see handset settings page 13).
2. If the handset is off the base, you will need to press
to answer the call. The display
will show the caller ID information after the first ring.
3. When you are finished, push
or place the handset back on the base.
BASIC OPERATION
