Detection
Your Detector
14 English
Detection
•
Signals Detected
The tables on the following pages show you the types of
Signals
your detector
will detect, as well as the voice and visual alerts it provides for each of them.
Audio Alerts
In
Voice Alert
mode you will first hear several tones, then a voice message
announcing the type of signal detected, followed by more tones. In
Tone Alert
mode, you will hear the tones only.
In both
Voice Alert
and
Tone Alert
modes, a distinctly different alert tone is
used for each type of signal detected (including separate tones for each laser
signal). For X, K, Ka and Ku band radar signals, the tones will repeat faster as
you approach the signal source. The repeat rate of the tones gives you useful
information about the signal detected. (See responding to alerts on page 17.)
Visual Display
An indication of the type of signal detected will appear in the DigiView Data
Display. During X, K, Ka and Ku alerts, you will also see from 1 to 5 vertical
bars, indicating the strength of the signal detected.
Signal Strength Chart
Signal Strength = 1
(Weakest Signal)
-
Signal Strength = 2
-
- -
Signal Strength = 3
-
-
- -
- - -
Signal Strength = 4
-
- -
- -
- - -
- - - -
Signal Strength = 5
(Strongest Signal)
-
- _
- -
- - -
- - -
- - - -
- - - - _
To Set the IntelliMute Activation Point
Press and hold
the
IntelliMute
button for two
seconds.
Tone
Voice
Visual Display
Two beeps
Set Engine Revs
Press IntelliMute
button again at
desired RPMs
Rev your engine to
the level you wish
to set (recommend
slightly above idle)
and hold revs steady
for two seconds.
None
None
None
At the desired
rev level, press
and release the
IntelliMute
button.
Three beeps
IntelliMute Set
IntelliMute Set!
Settings
Your Detector
Nothing
Comes Close to a Cobra
®
11
Tone
Voice
Visual Display
Four beeps
IntelliMute Not
Set, Please Try
Again
followed by
IntelliMute not set
Please try again
One beep
IntelliMute Off
IntelliMute Off
NOTE
If the unit is unable to sense usable pulses within three
seconds or if you do not set a rev point within 20 seconds
of beginning these steps, IntelliMute will indicate an error
and automatically turn off.
Press Int...
button ag...
desired RPMs
Hold IntelliMute Button
Intelli
Mute
Set!
Rev Level Set
IntelliMu...
Please tr...
IntelliMute
Not Set
Intelli
Mute
Off
IntelliMute Off
IntelliMute Button
Press and hold for
two seconds
10216_XRS9540_PH2.qxd 8/7/07 1:28 PM Page 11
