- 16 -
area.
11. STORAGE INSTRUCTIONS (OFF SEASON)
The following steps should be taken to prepare the lawn mower for storage at the end of the mowing season.
1. Drain the fuel from the engine by running the engine until it stops.
a)
Start the engine and let it run until it has used up all remaining petrol and stalls.
b) Remove the spark plug. Use an oilcan to fill approx. 20 ml oil into the combustion chamber. Operate the starter to evenly
distribute the oil in the combustion chamber. Replace the spark plug.
2. Clean and grease the lawnmower carefully as d
escribed above under “Lubrication”.
3. Slightly grease the cutter to avoid corrosion.
4. Store the lawnmower in a dry, clean and frost-protected place.
CAUTION! The engine must have completely cooled down before storing the lawnmower.
NOTE: - When storing any type of power equipment in an unventilated or material storage shed,
-Care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the equipment, especially cables and all
moving parts.
- Be careful not to bend or kink cables.
- If the starter rope becomes disconnected from rope guide on the handle, disconnect and ground the spark plug wire. Depress
the blade control handle and pull the starter rope out from the engine slowly. Slip the starter rope into the rope guide bolt on the
handle.
Transport
Turn the engine off. Ensure not to bend or damage the cutter when pushing the lawnmower over obstacles.
