Caring for Your microTALK
®
Radio
•
Your microTALK
®
radio will give you years of trouble-free service
if cared for properly. Handle the radio gently. Keep the radio away from
dust. Never put the radio in water or in a damp place. Avoid exposure to
extreme temperatures.
Installing Batteries
•
To install or replace batteries:
1.
Remove belt clip by releasing belt clip
latch and sliding clip up.
2.
Pull up on the battery door latch to remove the
battery compartment cover.
3.
Insert the supplied three AA rechargeable
batteries or non-rechargeable alkaline batteries.
Position batteries according to polarity markings.
4.
Replace battery compartment cover and
belt clip.
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
To charge batteries in radio:
1.
Check to see that the batteries have been
inserted properly.
2.
Insert the cable into the charge jack located at
the top of the radio.
3.
Plug the cable into USB-compatible power port.
Use only the supplied rechargeable batteries and charger for recharging
your Cobra microTALK radio.
Cobra recommends your radio is turned off while being charged.
Non-rechargeable alkaline batteries can also be used in your radio.
VO
LUME
CALL
MODE
CHANNEL
VO
LUME
CALL
MODE
CHANNEL
Remove Belt Clip
Pull Up Lock Latch
Insert Batteries
Operation
Customer Assistance Warranty
Introduction
Radio Charger Jack
