IMPORTANTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS CAREFULLY BEFORE USE
.
1.
Do not allow children to use the Garden Cart Trolley unsupervised. It is NOT a toy.
2.
Always distribute payload evenly over the surface of the bed.
3.
Do not lay any items on top of the fence. Lower the fence side panels before loading
objects into the Garden Cart Trolley.
4.
Do not load the Garden Cart Trolley with more than 300kgs.
5.
If any parts become damaged, broken or misplaced do not use the Garden Cart Trolley
until replacement parts can be obtained and fitted.
6.
Do not operate or use on objects than can cause damage to the pneumatic tires or tubes.
7.
Do not inflate tires to more than 30 psi.
8.
SAVE THESE INSTRUCTIONS.
ASSEMBLY INSTRUCTIONS
Your Garden Cart Trolley requires assembly. Account for all parts and hardware before
beginning assembly. If any parts are missing, damaged or if you have questions or need
additional instructions please call your retailer.
Tools required for assembly
:
Medium size slot screwdriver 6, 8 and a 12mm open end wrench and/or two medium
adjustable wrenches. For easier assembly we recommend two people assemble this product.
Use the cardboard from the carton to keep from scratching or damaging the finish
Refer to the exploded drawing and the parts list on the following pages during assembly.
STEP 1
Turn the Garden Cart Trolley bed (1) upside down so that the underside is facing up.
STEP 2
Assemble the Rear Support Assembly to the bed (1) using 6 Carriage Support Bolts, 6,
(8mm) washers and 6, (8mm ) Nuts. Attach the Rear Axle Support to the back of the bed and
then attach the left and right Support Axle Braces. Tighten all securely.
STEP 3
There are four shoulder bolts three short and one long. Be sure to use the long shoulder
bolt (8 X 17mm) in the front centre location of the steering mechanism. Assemble the Front Support
Assembly completely before attaching the completed assembly to the Bed.
A.
Attach the Steering Link Connector to the two axle guides using 2, (8x15mm) steering
Assembly shoulder Bolts (short, 6mm) Washers and (6mm Nuts).
NOTE:
Place the
Steering Link Connector on top of the axle guides.
B.
Place the Yoke into position on the Front Axle Support and secure to the Steering Link
Connector using 1,(8 x15mm ) Steering Assembly Shoulder Bolts (short), (6mm
Washer ) and (6mm Nut).
C.
Attach the Centre Front Axle brace to the Assembly as shown. Use 1, (8x17mm)
Steering Assembly Shoulder Bolt (long), (6mm) Washer and (6mm) Nut.
D.
Assembly the completed Front Support Assemble to the Bed using 4,Carriage Support
Bolts, (8mm) Nuts and Washers.
