Cobra ESD 9560, Operating Instructions Manual

Page: 8 / 17

3
O P E R AT I O N •
S E T T I N G S
3
O P E R AT I O N •
S E T T I N G S
11 10
Auto Mute Mode
Auto Mute will automatically reduce the
audio volume of all alerts after 4 seconds
for as long as the signal is detected. When
you turn Auto Mute on or off you will hear
2 beeps for Auto Mute on and 1 beep for
Auto Mute off.(See page 7 for instructions
on using the Program mode to select
Auto Mute.)
The factory setting for Auto Mute is ON.
Muting an Alert
Your ESD-9560 allows you to quickly
turn off an audio alert by momentarily
pressing and releasing the PROG/MUTE
button. If you press and release the
PROG/MUTE button a second time
during the alert, the audio alert will be
turned back on.
Auxiliary Audio Jack
Use to connect an external speaker in
environments with high ambient noise
levels. The internal speaker will be
disconnected.
N W
B r i g h t
c
s
PROG/MUTE button
Press and release
Setting the SmartMute
™
Activation Point
Your ESD-9560 must be installed in
your vehicle.
Caution: Do not attempt to set the rev
point while driving. Your vehicle should
be
parked and idling .
SmartMute™ must be turned on.
1.
2.
Procedure
In Program mode, go to Set
SmartMute. Press and release the
SET/CITY button to begin
setting SmartMute™ .
Tone
2 beeps
Visual Display
Press SET again at
desired RPMs...
Tone
1 beep
Visual Display
appears
Procedure
Rev your engine to the level you
wish to set. Rev the engine
slightly above idle and hold revs
steady for 2 seconds.
Tone
none
Visual Display
none
NOTE: If the unit is unable to sense
usable pulses within three seconds,
SmartMute™ will indicate an error and
automatically turn off.
1 beep Error
SmartOff
Press SET again...
E r r o r
Smart
SET!
SmartOff
E r r o r
SmartOff
3.
4.
Procedure
Press and release either the
SELECT/DIM
button to proceed
to the next user mode or the
PROG/MUTE button to exit the
Program mode.
Tone
none
Visual Display
none
Tone
1 beep
Visual Display
appears
Procedure
At the desired rev level,
press and release the
SET/CITY button.
Tone
3 beeps
Visual Display
Smart
then
SET!
1 beep Error
SmartOff
NOTE: If you do not set a rev point
within 20 seconds of beginning these
steps, SmartMute™ will indicate an
error and automatically turn off.