10
4. If the oil level is near or below the lower limit mark on the dipstick, remove the oil filler cap/dipstick(8), and fill
with the recommended oil to the upper limit mark (bottom edge of .the oil fill hole). Do not overfill.
5. Reinstall the oil filler cap/dipstick (8). (See Fig. 6)
Fig. 6
CAUT CAUTION:
This engine is delivered without oil, be sure to put oil in the engine before starting. Use a clean,
detergent and high quality oil SAE30 and API.SG, SH or SJ classification.
9.6.3 OIL CHANGE
Drain the engine oil when the engine is warm, warm oil drain is quickly and complete. (See Fig. 7)
Fig. 7
8. Oil filter cap/dipstick
A. Sealing washer
B. Drain bolt
1. Place a suitable container next to the engine to catch the used oil.
2. Drain the oil into the container by slightly tipping the engine toward the oil filler cap/dipstick after remove the
drain bolt and sealing washer.
NOTE:
Please dispose of used oil in a manner that is compatible with the environment. We suggest you
take used oil in a sealed container to your local recycling center or service station for reclamation. Do not throw
it in the trash or pour it on the ground or down a drain.
3. Remove the dipstick
4. Install and tighten the drain bolt and sealing washer after oil is totally drained out.
5 Pour the recommended oil slowly into the oil fill. Do not overfill. After adding oil, wait for one minute and then
check the oil lever by using dipstick. Oil lever should be between lower limit and upper limit
（
See Fig. 9).
6. Install and tighten dipstick
Engine Oil Capacity: 0.42 US qt (0.4L)
8
8
