12
Setting rear brake pedal position (see figure 2b):
1. Loosen the lock nut (10mm wrench).
2. Adjust the brake lever stop (10mm wrench) so that the lever is comfortably
reachable in both:
a. Standing riding position, and
Figure 2b
b. Sitting riding
position.
3. Tighten the lock nut
(10 mm wrench).
CAUTION:
Adequate pedal free play is
required so that the brake
pads do not drag on the rotor.
1” MINIMUM.
Make sure that the free play
locking clip is installed such
that one must push forward,
toward the front of the bike, to
remove. Otherwise the clip is
apt to come undone while riding.
To adjust (see figure 2b):
1. Loosen the lock nut (10mm).
2. Undo the free play locking clip from around the brake adjustor (plunger), with
your hand by pushing it forward.
3. Slide the pin of the locking free play locking clip from the brake lever
4. Adjust as needed by rotating the clevis on the end of the adjustor (plunger).
NOTE:
Turning the clevis Clockwise will lengthen the adjustor (plunger), removing free
play from the system, and turning the clevis Counter-Clockwise will shorten the adjustor
(plunger) adding free play to the system.
Summary of Contents for CX50 2014 5R King
Page 1: ......
Page 26: ...24 Parts Engine Clutch and Kick Lever...
Page 32: ...30 Parts Forks Leg Assembly Brake Side...
